Tabla de contenido
GB
PRODUCT CHARACTERISTICS
The spotlight is designed to illuminate small open spaces: building façades, monuments, ad-
vertisements, etc. The light source consists of white LEDs, which means low power consump-
tion and low power loss due to heating of the spotlight. The spotlight housing is made of metal.
The light source is protected by tempered glass with a gasket embedded in the frame. The
lamp is mounted by means of a bracket which allows the luminaire to be set vertically at an
appropriate angle.
SAFETY INSTRUCTIONS
A qualifi ed electrician is required to install the spotlight.
Before starting the installation, switch off the power supply to the mains to which the spotlight
is to be connected! Failure to do so may lead to electric shock, resulting in serious injury or
even death.
The luminaire has a non-replaceable glass and in case of damage or breakage of the protective
glass, the entire spotlight should be replaced immediately. The luminaire must not be used
without the protective glass or with damaged protective glass!
The electrical wiring system powering the lamp should be effi cient, periodically checked, with
properly selected fuses and should provide protection against electric shock through quick
shutdown.
Never use a lamp with visible mechanical damage, damage to the power cable insulation, bro-
ken spotlight glass, or other visible damage. Damaged power supply cable cannot be repaired
and must be replaced in their entirety by a qualifi ed specialist. All adjustment and mounting
operations must be carried out with the lamp power supply disconnected.
Do not touch the spotlight housing, as it becomes hot during operation and may cause burns.
SPOTLIGHT OPERATION
Spotlight without a motion sensor
Fix the spotlight to the wall or other fi xed element with screws or bolts through the openings in
the mounting bracket, so that the bracket is fi rmly and securely fastened to the surface. Make
sure that the lamp is mounted according to the instructions in Figure (II).
By tightening the bracket screws you can set the lamp in one specifi c position.
Spotlight with a motion sensor
The installation should be carried out as for a spotlight without a motion sensor, but the motion
sensor's operating principle shall be taken into account when selecting the installation location.
The sensor is designed so that it works best when mounted at a height of approximately 3
metres from the ground. Avoid placing the sensor near trees or bushes which may cause the
device to switch on in windy weather. Avoid directing or placing the device near heat sources,
as this may cause its undesired operation. Avoid directing the sensor towards bright light, as
the device will not operate at the minimum (minus sign) setting of the knob marked "LUX". Avoid
mounting in locations with strong electromagnetic interference, as this may cause undesired
switching on of the device. The sensor is the most sensitive to motion across the detection
area, unlike motion towards or away from the sensor. Therefore, the sensor must be positioned
so that the movement is transverse to the sensor axis.
8 8
OPERATING INSTRUCTIONS
Tabla de contenido
