Furrion VISION S FOS07TASR Manual De Usuario página 20

Install and Use Monitor
Pair with a camera
If this monitor comes in a bundle with one or
more Furrion Vision S cameras, it is paired
with the camera(s) by default. If you cannot
find the video from the camera on the monitor
screen or you have a standalone camera,
follow the procedures below for pairing.
Note: For bundles with a sharkfin camera
but no rear camera (such as FOS05TASF /
FOS07TASF), the sharkfin camera is paired
to the REAR CAM channel instead of the
DOOR CAM channel by default.
1. Ensure you have turned on the monitor
and camera(s) to be paired (see the
installation and wiring section of each
camera for details).
2. Press the Menu button on the right of the
monitor to enter the setup menu.
3. Tap PAIRING and then select the camera
to be paired with the monitor.
4. Press the Monitor Pairing button on the
camera (doorway security/rear camera
shown) to pair it with the monitor.
5. Repeat the steps to pair the other
available cameras. Erect antennas
(if available) on both the monitor and
camera(s). Ensure the signal strength is
OK.
CCD-0005559 Rev: 04-29-22
Good Signal
6. Tap to choose a view mode and then a
camera for view as you like.
DOOR
LEFT MODE
REAR
Activate the Monitor
When the monitor is off:
Press the Menu button on the right of the
monitor to turn it on and enter the menu
setting page.
When the monitor is on:
Press and hold the Menu button to activate
the menu setting page.
NOTES:
The rear or doorway camera transmits a
−
clear and wide image with audio from the
area behind the vehicle or at the vehicle
door to the monitor inside. To avoid
unnecessary noise when the vehicle
is moving, you can mute your vehicle
speaker system.
− The side cameras transmit clear images
at both sides of your vehicle to the
monitor.
− When the monitor is off, it can turn on
again automatically and display camera
images after receiving a video signal
on the 2.4GHz frequency band from a
camera.
The monitor adjusts color, brightness,
−
and contrast automatically for either
daytime or nighttime viewing. At night the
picture will appear black and white. This
is due to the low light level and is normal.
The monitor in a wireless system is
−
always watching for a video signal when
- 20 -
Poor Signal
RIGHT