Diagram A:
Grind Guide
GENERAL CLEANING
If the grinder is used daily, the burrs should be cleaned at least
every three months using tablets (see below for Automatic Cleaning)
or with a stiff brush.
To clean burrs, remove the burrs following the instructions in the
"Removing and Replacing Burrs" section.
Do NOT immerse the grinder in water. Do NOT wash the burrs
with water.
Never place fingers into the grind chute while product is plugged in.
Using the provided brush, gently brush coffee dust off of the burrs
and replace burrs following the instructions in the "Removing and
Replacing Burrs" section.
To wash the catch, wipe gently with a soft cloth and warm soapy
water. Dry with a dry cloth after cleaning.
Wipe grinder exterior and load bin with a soft, damp cloth.
10
AUTOMATIC CLEANING
A fast way to clean your grinder is using grinder cleaning tablets
like Urnex Grindz™ grinder cleaning tablets. These are designed to
prevent clogging by freeing coffee particles stuck to the burrs and
absorbing/removing odors and coffee oil residue.
To use cleaning tablets, make sure all beans are run through your
grinder by running it for 10-20 seconds. Use the cleaning tablet
instructions to place appropriate amount into grinder. Adjust the
grind setting to 11 and press the power button to run the grinder.
Grind all of the tablets into the catch. Once complete, we
recommend grinding approximately 30 g coffee to remove any tablet
residue. Discard the ground tablets/coffee from the catch and clean.
MAINTENANCE
Any other servicing should be performed
by an authorized service representative.
CLEARING A JAMMED GRINDER
On occasion, Ode Brew Grinder may become jammed and stop
grinding. When this occurs, the grinder will stop grinding before
it has finished all the coffee in the hopper and beep "SOS"
(save our ship).
Minor jams can be cleared as follows:
1. Check that the catch is empty. Turn the grinds dial to setting 11.
2. Tap the grinder firmly on the side several times and shake.
3. Press the power button and continue to firmly tap the side of the
grinder for several seconds. If grinding resumes, the jam is cleared.
If not, proceed to the instructions for clearing a major jam.
11