Iseki PE3500 Manual Del Usuario página 20

www.iseki.fr
PE3500
1. INTRODUCTION AND USES
Read this manual carefully before starting to use the sprayer and pay special
attention to the maintenance recommendations, as well as their use for
correct operation and useful life.
The company reserves the rights to changes the composition of the product
without prior notice as well as its technical characteristics. No claims can be
derived from the data and illustrations in this manual. The original manual
is written in Spanish, so it will prevail over the rest, in case of conflict or
contradictions between other languages.
This sprayer is specially designed for use with phytosanitary products such
as fungicides, insecticides or herbicides (pH scale min. 5 - 14 max.). It can
be used both for gardening and small farms. In no case should it be used
to spray flammable or industrial products such as solvents, alkalis or acids.
2. COMPOSITION AND START-UP
Before starting work, you must finish charging the battery (during storage
it may have lost some of its charge). To do this, the battery must be
disconnected from the sprayer.
Plug the charger into the mains and connect it to the battery until it is fully
charged. When the charge level is full, the battery LEDs will stop flashing
and stay on.
The sprayer's operating temperature range is 1 ° to 50 ° C.
To start working with ISEKI PE3500, press the 3S button and a green light
will turn on, the sprayer will start at speed 1 (low pressure) suitable for
herbicide treatments, pressing a second time the indicator light will change
to orange light, we will get speed 2 (medium pressure) suitable for herbicide
and insecticide treatments (according to needs and nozzle used), pressing
the indicator for the third time will change to red light , we will obtain speed
3 (high pressure) suitable for insecticide treatments. Pressing for the fourth
time the indicator light will turn off and the sprayer will stop. In standby
mode, the sprayer will be ready to be used again when required.
— 18 —