KNOVA KN RO-1313 Manual De Instrucciones página 9

OPERATION
NOTICE: The speed may be changed while the router is "ON",
but do not change the speed if the cutter bit is in the workpiece.
WARNING
Before operating your router, follow all
safety instructions in this manual. Failure to do so
could result in serious personal injury.
NOTICE: Choose the applicable cutting speed according
the bit diameter and the material being cut.
EDGE ROUTING OR INTERNAL ROUTING (FIG. 12)
For ease of operation and to maintain proper control, your
router has two handles, one on each side of the router base.
When operating the router, always hold it firmly with both hands
(FIG. 12).
EDGE ROUTING (FIG. 13)
1. With the depth-of-cut set, place the router on the edge
of workpiece, making sure that the cutter does not contact
the workpiece.
2. Turn the router "ON," and allow the router motor to reach
the selected speed.
Variable-speed dial
Fig. 11
Fig. 12
3. To begin the cut, gradually feed the cutter bit into
the edge of the workpiece.
4. When the cut is complete, turn the router motor "OFF"
and allow the cutter bit come to a complete stop before
removing it from the workpiece.
5. Unplug the
router from
the power
source, and
inspect the
finished cut.
Fig. 13
WARNING
Always securely clamp your workpiece
and keep a firm grip on the router base with both
hands at all times. Failure to do so could result in
loss of control causing possible serious personal
injury.
WARNING
Removing the cutter bit from
the workpiece while it is still rotating could damage
the workpiece and result in loss of control, causing
serious personal injury.
INTERNAL ROUTING WITH FIXED BASE (FIG. 14)
1. With the depth-of-cut set, tilt the router and place it on
the workpiece with the leading edge of the sub-base
contacting the workpiece first (FIG. 14).
2. Turn the router motor "ON" and allow the router motor
to reach the selected speed, being careful not to allow
the cutter bit to contact the workpiece.
3. To begin your cut, gradually lower the cutter bit into
the workpiece until the subbase is flush with the workpiece
(FIG. 14).
4. When the cut is complete, turn the router motor "OFF"
and allow the cutter bit come to a complete stop before
removing it from the workpiece.
5. Unplug the router from power source, place the router
upside down on the worktable, and inspect the finished
cut in the workpiece.