Install Wheel Kit; Add Engine Oil And Fuel - Speed Clean 2000PSI Instrucciones De Uso

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

Install Wheel Kit

The wheel kit is designed to greatly improve the portability
of your pressure washer.
NOTE: Wheel kit is not intended for over-the-road use.
Refer to Figure 2 and install the wheel kit as follows:
1. Place the bottom of the pressure washer frame on a flat,
even surface.Temporarily place unit on blocks to ease
assembly.
2. Slide axle through holes in frame, as shown in Figure 2.
Figure 2 — Install Wheel Kit
SpeedClean™ 2000 PSI Pressure Washer
www.mymowerparts.com
3. Slide a wheel over the axle.
NOTE: Be sure to install wheel with raised hub inboard.
4. Retain wheel on axle stud with retaining pin.
5. Repeat step 3 and 4 to secure second wheel.
6. Remove the temporary blocks.

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
7