Start Up; Cutting Height Adjustment - Truper ROU-MN Manual

Start up

Cutting height adjustment

CAUTION • Before adjusting the height of cut, turn
off and disconnect the router from the power source.
• Rest the router base on a flat, level surface with the front
of the router facing you.
• Open the lever (F) on the stationary base.
• With the cutter bit already installed, push down on the
cylinder until the bit is very close to the surface on which
the outer is resting (1).
• Turn the fine height adjustment knob (G) until the drill
bit barely touches the surface on which the router is
resting. This point should be considered as 0 penetration.
• Place the router on two pieces of scrap work that are
level and position it so that the drill bit can be lowered
underneath the base of the router (2).
• Rotate the fine height adjustment knob (G) to lower the
drill bit to the desired depth of cut. Turn in the opposite
direction to raise the bit.
• Once you determine the depth of cut, close the lever (F)
on the fixed base.
Start-up and operation control
• Connect the router to the power source.
• Use the switch (A) to turn the router motor on or off. To
turn on press the switch to the "O" mark, to turn off press
the switch to the "I" mark.
CAUTION • When turning the motor on, wait until
the drill bit reaches full speed to make contact with the
workpiece.
CAUTION • When turning the motor off, wait for
the drill bit to come to a complete stop before removing
the drill bit from the workpiece.
• The motor is configured to minimize torque by limiting
its speed during start-up, which increases its life.
• The motor features electronic feedback control that
maintains constant speed under load to provide proper
control and ensure a smooth finish.
1
G
2
1
A
F
9
ENGLISH