Tabla de contenido
WARNING
• Disconnect the power cord from the
power supply before carrying out any type of adjustment,
service or maintenance on the washer.
Cleaning and Care
• Keep the washer free of dust. Never use water or
chemical liquids to clean the washer. Clean only using a dry
and clean cloth.
• Always keep the ventilation slots clean and free of
obstructions to guarantee the proper cooling of the motor.
• Regularly inspect all the mounting screws and double
check tightness. If any of these screws is loose, tighten
immediately.
• The motor is the washer heart. Use care so that it will not
be affected by oil or water.
• Check the power cable often to detect any kind of
damage. In the event there is some damage go to a
Authorized Service Center to have it
replaced.
Connections Lubrication
• The connections in the washer hoses, the high-pressure
gun and the lance shall be cleaned regularly. To prevent
leaks and damage to the seals in each connection, lubricate
using non-water soluble grease.
Nozzle Lubrication
• The nozzles shall be regularly lubricated with non-water
soluble grease or light oil.
• A blocked nozzle increases importantly the pressure in the
pump. Clean immediately:
1) Remove the blockage in the nozzle inserting the nozzle
cleaner through the center orifice.
2) Purge the nozzle with water. Start the washer and press
the washer high-pressure gun. If the pressure is still too high
repeat steps 1 and 2.
ENGLISH
10
Maintenance
Washer Lubrication
• Every six months, take the machine to a
Authorized Service Center to carry
out maintenance (lubricate valves and oil change).
CAUTION
• In case there is an oil leak go to a
Authorized Service Center.
Water Filter
• Any foreign matter entering the washer pump may cause
damage. the washer is built with a water filter to prevent
this possibility.
• The inner screen in the washer filter shall always be kept
clean to keep a continuous flow of water into the washer
and prevent damaging the pump.
• To clean the screen, remove the filter from the garden
hose connector and unscrew to remove the screen. Handle
with care to prevent damaging the screen.
• Set back immediately both screen and connector to
prevent foreign particles entering into the pump.
CAUTION
Before closing the filter, make sure that the
screen (A) is assembled in the center of the seal (B) and
not over it, this to avoid leaks or damage to the filter.
A
Storing in Winter time
• Turn the washer OFF and press the trigger to release the
pressure trapped inside the unit.
• Remove both the garden hose and the pressure hose.
• Turn ON the washer and leave it running 5 seconds to
eliminate any water trapped inside the pump.
• Disconnect the washer and store the power cord.
• Store the washer and accessories in a dry environment
and with controlled temperature. Do not store the washer
and accessories where temperature may drop to 40 °F.
CAUTION
DAMAGES DUE TO FREEZING ARE NOT
COVERED IN THE WARRANTY.
B
Tabla de contenido
