Tabla de contenido
NOTE: Some of these tools may not be used for each installation.
Lint free cloths
3M™ Prep-Sol or DuPont Prep-Sol
Isopropyl alcohol (IPA) cleaner (70% rubbing alcohol or mix 2 parts IPA
to 1 part water)
3M™ Tape Primer 94
Scotch™ Masking Tape – 1" to 2" roll
3M™ Squeegee PA1-G Gold (one edge covered with 3M™ Fastener
SJ3523 (Loop) from 3M™ Hook and Loop Fasteners and other edge
covered with PTFE tape)
Protected cutter
Tape measure
Temperature-controlled electric heat gun capable of attaining at least
650°F (344°C)
Infrared temperature sensor (e.g., 3M™ Infrared Thermometer IR-500)
CAUTION: When handling any chemical products, read the manufacturers'
container labels and the Safety Data Sheets (SDS) for important health, safety and
environmental information. To obtain SDS sheets for 3M products go to
3M.com/MSDS, or by mail or in case of an emergency, call 1-800-364-3577 or
1-651-737-6501.
CAUTION: When using any equipment, always follow the manufacturers'
instructions for safe operation.
CAUTION: Any activity performed for a long period of time in an awkward position
or with a high amount of force is potentially a risk for causing musculoskeletal
strain, pain or injury. When applying film, follow these practices to improve
comfort and avoid injury:
Alternative your tasks during the application.
Schedule regular breaks.
Perform stretches or do exercises to improve circulation.
Avoid awkward reaching.
Air Quality Regulations: State Volatile Organic Compound (VOC) regulations may
prohibit the use of certain cleaning chemicals with VOC's in graphic arts coatings
and printing operations. For example, the California South Coast Air Quality
Management District prohibits use of certain solvent-based solutions without a
permit and other California AQMD's prohibit use of certain solutions without a
permit or a regulatory exemption. Check with your State environmental authorities
to determine whether use of this solution may be restricted or prohibited.
For best results with your film application, ensure the following conditions are
met prior to application.
1. Do not wash vehicle within 12 hours of the application time. If washed in an
automatic car wash, do not select the "spot-free rinse" option.
2. Ensure the vehicle surface is completely dry.
3. Maintain the vehicle and ambient temperature between 16° to 32°C
(61° to 90°F).
4. Ensure the application environment is clean and well lit.
5. Sweep the work area clean to remove any loose dirt or particles.
6. Use a clean tabletop for handling the film. Do not place the film on the floor
Material and Tools
Health and Safety
Pre-Application Instructions
1. Dampen a lint free cloth with the solvent based cleaner.
2. Wipe the hood with the damp cloth. Then, immediately wipe dry with a dry
cloth.
3. Repeat Steps 1 and 2 using the alcohol based cleaner.
4. It is essential that the underside of the hood be cleaned too, all the way to the
body seam, as the film will be wrapped to that point.
Assuming the ambient application temperature was above the recommended
minimum of 16º C (60º F), keep the vehicle indoors as follows:
16ºC (60º F) and above: not required
5º to 16ºC (40 to 59ºF): 1 hour
Below 5ºC (40ºF): 3 hours
Ensure your customer receives the 3M Glove Box Warranty for Personalized
Vehicle Graphics found at the end of the I-Sheet.
The information contained and techniques described herein are believed to be
reliable, but 3M makes no warranties, express or implied, including but not limited
to any implied warranty of merchantability or fitness for a particular purpose.
Except where prohibited by law, 3M SHALL NOT UNDER ANY CIRCUMSTANCES
BE LIABLE TO PURCHASER OR USER FOR ANY DIRECT, INDIRECT, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED
TO, LABOR, NON-3M MATERIAL CHARGES, LOSS OF PROFITS, REVENUE,
BUSINESS, OPPORTUNITY, OR GOODWILL) RESULTING FROM OR IN ANY
WAY RELATED TO SELLER'S PRODUCTS OR SERVICES. This limitation of liability
applies regardless of the legal or equitable theory under which such losses or
damages are sought including breach of contract, breach of warranty, negligence,
strict liability, or any ther legal or equitable theory.
3M and Scotch are trademarks of 3M.
Ford
is a trademark or registered trademark of
All other trademarks are the property of their rightful owners
Clean the Vehicle
After Application
3M Glove Box Warranty
Disclaimer
Limitation of Liability
Trademarks
Ford Motoring
Company.
Page 5 of 10
Tabla de contenido
