Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. DISPLAY AND OPERATING ELEMENTS
Clean Filter
Clean Filter
On/O
On/O
ON
6. OPERATION
6.1 Before each start-up
Before each start-up, make sure that the vacuum cleaner,
power cord, vacuum hose and accessories are not damaged.
It must also be ensured that the filter is inserted and not dam-
aged.
m Make sure that plugged-in power tools are not switched on.
The socket on the vacuum cleaner is live when the mains
plug is plugged in, regardless of the switch position.
6.2 Permanent filter cleaning
The vacuum cleaner is equipped with electromagnetic valves
that clean the filter by air back flushing. Each cleaning cycle
cleans the two chambers of the filter 2 times each. Cleaning
takes place automatically every 45 seconds after the last clean-
ing cycle.
If continuous cleaning is not necessary due to a low level of dust,
you can switch it off by deactivating the cleaning function (2).
Cleaning is active when the indicator light (2) on the control
panel lights up.
When working overhead with for example long-neck grinders,
make sure that the vacuuming is briefly reduced by the vacu-
um cleaner during the cleaning interval. This can cause the
tool to fall off the ceiling. Cleaning can be switched off for small
amounts of dust.
6.3 Insert fleece filter bag
1. Unlock the locking tabs and remove the motor head
2. Attach the fleece filter bag.
3. Put on the motor head and lock it with the locking tabs.
OFF
AUTO
1. Cleaning function On / Off (incl.) Control light
2. Device OFF
3. Standard mode
4. Automatic mode with tool connected
5. Power socket (max. 6 A*)
* Vacuum cleaner and power tools together should not consu-
me more than 15 A
6.4 Insert Waste Bag
1. Unlock the locking tabs and remove the motor head
2. Attach the Waste Bag and put it over the edge of the con-
tainer. Note that the holes provided above the flange must be
placed over the electrodes of the water cut-off.
3. Spread the Waste Bag against the inside of the container in
order to lose as little volume as possible.
4. Put on the motor head and lock it with the locking tabs.
6.5 Switching on the vacuum cleaner
The device allows 2 operating modes.
- Standard mode (5): Vacuum cleaner switches on immediately
- Automatic mode (6): The vacuum cleaner is in standby
mode for power tools and only switches on when a power
tool plugged into the socket (7) is switched on and switches
off again 5 seconds after the power tool is switched off.
The power of the vacuum cleaner can be adjusted continuous-
ly from 100% to 50% in both operating modes.
Plug in the mains plug of the device. Set the rotary switch of
the device to one of the two operating modes.
6.6 Dry vacuuming
See Fig. 3-11.
Before vacuuming, make sure that the filter, the vacuum clean-
er and the vacuum cleaner accessories used are dry to prevent
dust from sticking and becoming encrusted.
I 5
Tabla de contenido
