Dunsch DU10040-38C3 Instrucciones Originales página 33

Empty the grass catcher once it is full to avoid obstruction of the discharge
opening. Never run the mower again on the mulching grass to avoid obstruction
of the discharge opening and unnecessary motor overloading.
Blade
Always unplug the lawn mower before checking the blade in any way. After you
have stopped the motor, remember that the blade will still keep running for a
few seconds before it comes to a standstill. Never attempt to stop the blade.
Check at regular intervals if the blade is properly fastened, in good repair, and
whether it is well sharpened. Regrind or replace it, if necessary.
If the rotating blade hits any object stop the lawn mower and wait until the
blade has completely come to a standstill. Then check the condition of the blade
and the blade holder. Immediately replace the blade if it has got damaged.
To avoid possible damage to you, please make sure to follow the below
instructions during operation:
 Never use the machine without rear flap or grass catcher connected.
 Do not attempt to lift up the rear part of the machine, instead, to hold
up the front part of machine to get the machine re-start when it fails to
rotate owing to too strong grass.
 On slopes, always mow sideways, never up and down. Avoid extremely
steep slopes.
 Never put your hands or feet near or under rotating parts. Always keep
away from the discharge opening, if possible.
MAINTANCE
Before performing any maintenance or cleaning work, Always pull out the
battery pack!
Cleaning:
1. Do not spray the unit with water. Ingress of water may destroy the
Switch/plug combination unit and the electric motor.
2. Clean the unit with a cloth, hand brush, etc.
GB
31