General Cleaning - sunjoe 24V-HCSWP-CT Manual Del Operador

• Use protective gloves when handling the bar and chain.
• Keep the bar encased in its sheath, except when working
directly on the bar or the chain.
• Never dispose of oils or other polluting materials in
unauthorized places.
m
CAUTION!
If you notice anything unusual, such
as excessive vibrations or odd noises, shut the saw OFF
immediately. Remove the battery and check the saw for any
damage.
m
CAUTION!
To avoid overheating and damage to the
motor, always keep the ventilation slots clean and free of
sawdust and debris.

General Cleaning

It's recommended to clean the pruning saw after each use
for best performance. Use a cloth, brush or compressed air
to remove saw dust and splinters from the ventilation slots.
Only clean the housing of the pruning saw with mild soap and
a damp cloth. Never use strong cleaning agents or solvents
to clean the tool. Never immerse any part of the saw or allow
liquids to get inside the cordless power tool.
Storage
• To prevent corrosion, press the compression cap 3-4
times and run the saw for 30 seconds to lubricate the
chain evenly before storage.
• Place the bar sheath over the guide bar before storing.
• Do not store cordless pruning saw near chemicals, such
as fertilizers or other harsh solvents. Do not expose
the plastic parts of the unit to brake fluids, gasoline,
petroleum-based products, penetrating oils, or the like.
These products are often highly corrosive and may cause
permanent damage to the plastic parts of your unit.
• When not in use, your machine should be stored indoors
in a dry place, out of the reach of children.
Replacing the Guide Bar + Chain
m
WARNING!
Make sure the battery is not inserted
and the chain is covered by the sheath before replacing the
guide bar and chain. The operation should be completed on
a flat and stable surface, with adequate space for moving the
machine and its components.
m
WARNING!
Always wear heavy-duty gloves when
handling the bar and chain. Mount the bar and chain very
carefully so as not to impair the safety and efficacy of the
machine. If in doubt, contact an authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
service center at 1-866-SNOWJOE (1-866-766-9563).
m
DANGER!
Never start the motor before installing the
guide bar, chain, and sprocket cover. Without all these parts in
place, the guide bar and chain may fly off, exposing the user to
potentially serious injuries.
+
®
+ Sun Joe customer
® ®
16
Replace the guide bar if:
• There is excessive wear or obstructions inside the groove
of the guide bar.
• The guide bar is bent
• The guide bar is cracked
NOTE: It is normal to see burring on the edges of the
guide bar. You can smooth down any burrs with a file
instead of replacing it.
Refer to the table below for the specifications of the chain. You
should replace the chain if:
Drive Links Chain Pitch
32
• There is too much play between the links and rivets
• There are cracks in the chain
• Length of cutting edge has worn down to 5/32 in. (4 mm)
or less (Fig. 24).
Fig. 24
1. Loosen the tensioning wheel using the wrench and
remove the sprocket cover (Fig. 25).
Fig. 25
Tensioning
wheel Wrench
Chain Gauge
1/4 in. 0.043 in.
6.35 mm 1.1 mm
< 5/32 in.
(4 mm)
Sprocket
cover