Operation - Senix LSPG-M7 Manual Del Operador

Blade Control
Rope Guide
Grass Catcher
Recoil Starter Handle
BLADE CONTROL
The blade control is attached to the upper handle of the mower. Depress and hold
against the upper handle to operate. Release it to stop the engine and blade.
WARNING
This blade control is a safety device. Never attempt to bypass its operation.
CUTTING HEIGHT ADJUSTMENT LEVER
This product is designed with dual-lever height adjustment. The height of
front wheel and rear wheel can be respectively adjusted by two cutting height
adjustment levers which locate above the front wheel and rear wheel. 6 cutting
heights (from 1.25inch to 3.75inch) are available. To adjust the cutting height, refer
to the assembly section.
MULCHING COVER
The mulching cover is used for mulching purposes. Instead of collecting the grass
clippings in a grass catcher or using the side discharge chute, some mower models
have the option of recirculating the clippings back to the lawn. This is called
mulching. Close the mulching cover when mulching so that the clipped grass can
not discharge from side.
WWW.SENIXTOOLS.COM
Oil Tank Cap
Rear Wheel
Side Discharge Cover

OPERATION

GRASS CATCHER
Upper Handle
Handle Connecting Knob
Lower Handle
Rear Discharge Door
Mulching Cover
Cutting Height Adjustment Lever
You can use the grass catcher to collect clippings while you are operating the
mower. Attach the grass catcher following the instructions in assembly section.
When using the grass catcher, make sure the side discharge cover is removed and
the mulching cover is closed. This will contribute the efficiency of grass collection.
SIDE DISCHARGE COVER
Your mower is shipped as a mulcher. To discharge the grass clippings to the side,
follow the instructions in the assembly section to attach the side discharge cover.
Keep hands and feet away from the chute area on cutting deck. Refer to warning
label on the unit.
RECOIL STARTER
The recoil starter is attached to the right upper handle. Depress and hold the blade
control handle, then pull the recoil starter rope to start the unit.
PRIMER
The primer is located on the left side of the engine. The primer is used to pump gas
into the carburetor and aid in starting the engine.
Fuel Tank Cap
Primer
Front Wheel
WARNING
11