Idiomas disponibles
Idiomas disponibles
Clean the sponge by separating the cy-
clone and the filter in the direction of the
arrow shown in the figure.
Note: After completing the cleaning and
drying (replace if necessary), you can ins-
tall it in the reverse order of division.
Clean and brush the set
1. Press the padlock on the roller cover to
unlock the roller cover.
2. Remove the cover to remove the roller
from the groove and be able to clean it (it
cannot be washed with water and other li-
quids).
3. When cleaning or replacement is com-
pleted, reassemble it in the opposite order
of division (note the installation direction
of the rotating brush, it cannot be loaded
in the wrong direction).
EN
Instruction manual
Cordless Vacuum cleaner
Questions and answers
1. Engine does not start:
- Possible reason: The battery is off. / The
handheld vacuum is not installed correctly
in the body assembly (because the body
assembly requires a handheld vacuum to
provide power, which in itself cannot func-
tion independently).
- Solution: load the vacuum. / Install the
handheld vacuum and body assembly co-
rrectly.
2. Reduced solution:
- Possible reasons: The tank is full of dust.
/ The filter is full of dust. / The air duct of
the electric brush is blocked or the brush is
stopped. / Battery is low.
- Solutions: Empty the dust container. /
Clean or replace the filter. / Clean the roller
electric brush. / Fully charge the battery as
indicated in the charging section.
REF.: 07694
