Frequently Asked Questions - Car Keys Express GMPRR-7044-0 Manual Del Usuario

new remote for approximately 30 seconds.
9. Repeat step 8 for each additional remote to be programmed.
10. After all remotes have been added, turn the key to the Off position and
unplug the EZ Installer.
11. Press buttons on each remote to test they were properly programmed to
the vehicle.*
*Some vehicles may need to have the engine started and stopped, and the
driver's door opened and closed before the remotes will work.

FREQUENTLY ASKED QUESTIONS

Q: Can I use the same EZ Installer on other vehicles?
A: No. The EZ Installer will be locked to the first vehicle it is used on.
You may add more remotes to the same vehicle again as needed, but it
will not work on different vehicles. If the EZ Installer sounds 3 beeps at
1 second intervals, and then beeps rapidly, this signifies the device has
already been used on another vehicle. Visit CKESimpleKey.com or your
local retailer to purchase additional remotes.
Q: The new remote won't pair to my car. What should I do?
A: If the EZ Installer doesn't pair the remote to your car, most likely,
an incorrect dial position was used. In this case, the EZ Installer will
beep continuously after you press the pairing button. Check the
compatibility section on page 3 to confirm the correct dial position
for your make, model, year, and button configuration of your original
remote. Remove the EZ Installer, turn the Ignition off and try the
pairing process from step 1. If the remote still won't pair, please contact
customer service at (888) 598-8910.
Q: The EZ Installer was unplugged during the pairing process. What
should I do?
A: The EZ Installer must remain plugged into the on-board diagnostic
(OBD) port until pairing is complete. If the EZ Installer becomes
unplugged during the pairing process, turn the ignition to the OFF
position, remove the key, and begin the pairing process again.
USER GUIDE
5