Storage, Cleaning - Crivit 353799 2010 Instrucciones De Montaje

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
1. Fasten the telescopic pole (1) to the floor
with the long screws (5) and two washers (6)
(Fig. F).
2. Loosen the locking lever (1b) and pull out the
telescopic pole as far as needed (Fig. F).
Note: if the locking levers are not sitting firmly
against the telescopic pole, tighten the knurled
screws when the locking lever is open. The
locking levers must be stiff when they are being
closed.
3. Place the upper slip-resistant cap (4) on the
telescopic pole.
Note: make sure that the holes of the upper slip-re-
sistant cap and those of the telescopic pole line up.
4. Extend the telescopic pole between the ceiling
and the floor as much as possible with the
fastening screw (1c) (Fig. G).
The holes of the telescopic pole and the ceil-
ing must align perfectly (Fig. G).
5. Fasten the telescopic pole (1) to the ceiling
with the screws (5) (Fig. G).
6. Refasten the locking lever and tighten the
setscrews (1d) (Fig. H).
Attaching the crossbars
1. Remove the screws (1g) and the washers (1f)
from the telescopic pole.
2. Mount both crossbars (2) as shown in Figure I.
Aligning the crossbars
1. Loosen the screw (1g) and tilt the respective
crossbar into the desired position (Fig. K).
2. Tighten the screws once again to fasten the
crossbar.
3. Loosen the locking screw (1h) on the telescop-
ic pole and adjust the height of the respective
crossbar (Fig. L).
4. Fasten the respective crossbar with the locking
screw so that the crossbar cannot slide down
when weight is placed on it.
Attaching the hooks
1. Unscrew the locking screw (3a) from the
respective hook (3).
2. Mount the individual hooks as shown in
Figure J.
Changing the hook position
You can fasten the hooks either in the outer holes
or in the track of the crossbars (Fig. J).
1. Unscrew the locking screw (3a) from the
respective hook.
2. Slide the hook to the desired position (Fig. M).
3. Fasten the respective hook with the corre-
sponding locking screw.
Storage, cleaning
When not in use, always store the product clean
and dry at room temperature. Clean only with
water and wipe dry afterwards with a cloth.
IMPORTANT! Never clean the product with
harsh cleaning agents.
Disposal
Dispose of the article and the packaging materi-
als in accordance with current local regulations.
Packaging materials such as foil bags are not
suitable to be given to children. Keep the pack-
aging materials out of the reach of children.
Dispose of the products and the
packaging in an environmentally friendly
manner.
The recycling code is used to identify
various materials for recycling. The code
consists of the recycling symbol – which
is meant to reflect the recycling cycle – and a
number which identifies the material.
Notes on the guarantee and
service handling
The product was produced with great care and
under continuous quality control. DELTA-SPORT
HANDELSKONTOR GmbH gives private end
customers a three-year guarantee on this product
from the date of purchase (guarantee period)
in accordance with the following provisions.
The guarantee is only valid for material and
manufacturing defects. The guarantee does not
cover parts subject to normal wear and tear that
are thus considered wear parts (e.g. batteries)
or fragile parts such as switches, rechargeable
batteries, or parts made of glass.
GB/IE
13
Tabla de contenido
loading

Tabla de contenido