Installazione Del Muro - fortress TeleCom 750 VA Guia Del Usuario

Installazione del muro

The Fortress.TeleCom is shipped with screws and brackets to mount it to a wall surface. You
must attach one bracket to each side of the UPS, and then mount the UPS to the wall. Install the
UPS by following the instructions below. NOTE: The procedure requires two people.
1. Note that the brackets (items 1 and 2 in drawing) are not identical. They must be attached to
the Fortress.TeleCom so that the narrow side of key slots is up, as shown in the drawing
below.
2. Determine the construction type of the wall to which the UPS will be mounted. Also, decide
upon the position of the UPS on the wall, so the brackets can be attached properly to the
UPS.
3. Install one mounting bracket on the Fortress.TeleCom at a time to avoid removing the UPS
cover. Removing the cover could void the product warranty.
3.a. Remove the five screws (item 3) on the top side of the UPS that hold the UPS bottom
cover in place. Align the holes of the top bracket with the cover-screw holes. Then,
replace the screws to attach the bracket and secure the cover to the UPS.
3.b. Remove the five screws on the bottom side of the UPS that hold the UPS bottom cover
in place. Align the holes of the bottom bracket with the cover-screw holes. Then,
replace the screws to attach the bracket and secure the cover to the UPS.
4. Based upon the wall material, select the
required type of mounting screws (item 4): use
wood screws for wood studs, steel stud screws
for steel studs, or concrete screws for concrete
or concrete blocks.
5. Mark desired screw locations on the wall and
drill pilot holes for the four mounting screws:
two screws for each bracket. Locate the holes
to match the spacing between holes in the
brackets, and make sure that all holes are
drilled into structural material.
6. Partially screw all four screws into the wall,
leaving enough length exposed to position the
UPS onto the screws.
7. With the help of another person, lift the UPS
onto the screws and lower it until the screws
are in the key slots of brackets.
8. Tighten all four mounting screws to hold the
Fortress.TeleCom securely to the wall.
1
2
1 Top Bracket
2 Bottom Bracket
3 UPS Cover Screws (10)
4 Wall Mounting Screws (4)
77
3
4
ITALIANO