Regulatory Information - GoPro Volta Guia Del Usuario

Ocultar thumbs

Contenido

página de 24

/ 24
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Using Volta with Media Mod

Insert your GoPro into Media Mod (sold separately) as you normally would and

follow these steps:

1. Use your camera's mounting fingers to attach your GoPro to Volta.

Heads Up: Insert your camera into the mounting fingers with the Media Mod's

USB port on the same side as the camera cable and Thumb Screw. Rotate the

mounting fingers if needed to ensure that your camera is mounted properly.

2. Plug Volta's USB-C cable into the USB-C port on the back of your Media Mod.

3. Connect Volta to your camera via Bluetooth to use Volta's built-in camera

controls.

WARNING: Volta is not weather resistant when used with

Media Mod.

Resetting Volta

Press and hold the Mode + Power button

simultaneously for 8 seconds if you need to reset Volta.

Heads Up: You will not have to re-pair your camera if you reset Volta.

Notes

Here are a few important things to keep in mind while you're using Volta:

• Volta will enter power save mode if it is not used for 24 hours. Press any

button to wake it up.

• Disconnect Volta's Bluetooth connection to your camera if you want to

connect your camera to the GoPro Quik app. Press Bluetooth button

to disconnect.

• Volta can only pair and connect to one camera at a time.

• Volta's operating ambient temperature range is 14° F – 95° F (-10° C – 35° C).

It's normal charging temperature range is 32° F – 95° F (0° C – 35°C). Volta will

automatically shut down if it's too hot or too cold. The LEDs will blink red 4x

to show that it needs to return to its normal operating temperature before

the camera control buttons and camera charging will work. You can check its

status by pressing any button. The LEDs will blink red if it's not ready.

WARNING: Volta is not waterproof. Using it under water will

damage both Volta and your camera.