Idiomas disponibles
Idiomas disponibles
one at a time:
Repeat with the other handle.
When lifting with a hoist or similar equipment, hook a four-point harness
at least 1500 mm.
Unpack the machine.
The machine is supplied with its legs removed, these must be assem-
bled:
1. Fit the wheels into the rear legs and lock them with their cotters.
The height of the mixer should enable easy unloading into the wheelbar-
row used to move the mixed product around the worksite.
Ensure that the supply voltage corresponds to machine dataplate speci-
Ensure that the supply voltage corresponds to machine dataplate speci-
The power supply line must be suitably sized to prevent voltage drops.
Do not use cable winders. The electric cable wire size must take into
account the operating currents and length of the line to avoid excessive
voltage drops (table 4).
Table 4
Model
Type of motor
230 -220V
9 -9.4A
PLAM MIX 120
110 V
15 A
The power supply cables used on the site must have an outer jacket that
is resistant to crushing, wear and weather (e.g. H07RN-F).
Before connecting the machine to the electrical mains, ensure that all
-
Cable (mm²)
1.5
2.5
4.0
0 ÷ 19
20 ÷ 32
33 ÷ 50
0 ÷ 12
13 ÷ 19
20 ÷ 30
cord is in good condition and that the plugs and sockets (of the type
protected against jets of water) are not wet.
Connect the mains power cable to the plug on the electrical panel. Start
For best mixing results and regular operation, the mixer must be instal-
led on a level surface.
The machine must be started when the tank is empty.
The tank guard is equipped with bag breaker blades to facilitate using
premixed product. Load the mix components alternately, in the amounts
required for the type of product, so as to reduce mixing time as far as
possible.
Ruin the machine for as long as it takes to obtain an even mix of the
right consistency.
Empty the tank with the blades turning by opening its outlet by hand.
If any of the mix is left inside the tank for further use, the blades must
be left turning until it is used. We recommend leaving the mix inside the
tank as little as possible once it has reached the right consistency.
It may occur that the machine stops mixing because the mix is too den-
se.
To unjam the blades, proceed as follows:
2. Invert the direction of rotation of the blades by setting the switch
Every two months of operation, check:
Check weekly that the plug contacts on the electrical cabinet are clean,
dry and rust free.
14
GB
-
-
