Replacing The Device Fuse - Waeco CoolFreeze FR-145DC Instrucciones De Uso

_fr-145.book Seite 25 Montag, 14. August 2006 4:03 16
FR-145
➤ To deactivate the selection buttons (3 3 and 4, page 3), press them
longer than 3 seconds. To re-activate the selection, press both buttons
once again for about 3 seconds.
Removing the partition
The cooler has partition that divides the cooling area into two compartments.
The partition can be removed as needed:
➤ Using a screwdriver or similar tool, press the bolts (4 2, page 4) on both
sides of the partition inward (4 1, page 4).
➤ Take out the partition.
The partition can only replaced in the same position.
After you have replaced the partition, lock it back into place with
the bolts (4 2, page 4).
Switching off and storing the cooler
If you do not intend to use the cooler for a prolonged period, proceed as follows:
➤ Pull out the connection cable.
➤ Clean the cooler (see chapter "Cleaning and maintenance" on page 26).
➤ Leave the cover slightly open. This prevents odour build-up.
6.5

Replacing the device fuse

Replacing the fuse for the battery connection
➤ Unscrew the fuse insert (2 2, page 3) with a screwdriver.
➤ Replace the defective fuse with a new one that has the same rating (12 A).
➤ Screw the fuse insert back in.
Replacing the fuse for the AC mains
➤ Pry out the fuse insert (2 5, page 3) with a screwdriver.
➤ Replace the defective fuse with a new one that has the same rating
(F3, 15 AL).
The fuse insert contains a spare fuse.
➤ Press the fuse insert back into the housing.
Operation
25