Idiomas disponibles
Idiomas disponibles
ENG
yourself with the pressure-washer before use.
6
11
1
4
1. Inlet water hose.
2. Quick connector.
3. Tap connector.
4. High pressure hose.
5. Cleaning pin.
6. Gun.
7. Adjustable spray nozzle.
8. Water inlet connector.
9. Water inlet filter.
10. Detergent bottle.
11. Pressure washer.
USE INSTRUCTIONS.
Before starting up the pressure-washer, we
►
recommend that you carefully read all of the instructions
as indicated
Please respect all regulations regarding
►
the prevention of accidents, health and safety
directives, laws and applicable restrictions for work
places
The pressure-washer must only be used by
►
persons who have been instructed in its use and only
for the purposes for which it has been designed.
POWER SUPPLY.
Make sure the power supply is adapted to the
►
requirements shown on the information panel of
the pressure-washer (1)
voltage will make it operate slowly
7
performance and may cause the motor to overheat.
EXTENSION CORD.
9
If the working area is at some distance from the
►
power supply, use an extension cord of enough
diameter and quality.
8
ASSEMBLY.
Insert the adjustable spray nozzle into the gun;
►
push and turn the nozzle clockwise onto the gun
until locked
►
the gun for proper use (2)
10
pressure hose (3)
pressure washer, ensure that the high pressure
hose has been completely uncoiled
pressure washer is in operation, the high pressure
hose must not loop
hose to the gun; insert and quick-connect it tight to
2
avoid leakage
you can pull out high pressure hose (4)
the detergent nozzle into the gun
3
the detergent nozzle clockwise onto the gun until
hand tight to lock it in place (5)
connector and filter onto the water inlet pipe (6)
Attach the hose joint to both ends of the inlet
►
5
water hose, then connect the inlet water hose to
the water tap joint and pressure washer (7, 8 , 9)
Caution; prior to attach the quick connector to
►
pressure washer, check that filter is mounted in
the water inlet and that it is not blocked up, failure
to fit the filter will damage the pump valves.
STARTING UP.
Warning; high pressure hose may not loop
►
Warning; always turn off the motor before turning
►
off the water supply
occur to the motor if ran without water
the water supply tap fully
pressing the safety button first and then actuate
the trigger) for a few second; let the water flow out
from the nozzle
if so, please reconnect the water hose, the spray
gun or the lance to make sure each accessory
are connected perfectly
supply
Set the power switch at the on position
►
5
English
Using the motor at low
►
►
All attachments must be inserted into
Screw on the high
►
Caution; prior to operate the
►
Connect the high pressure
►
Push the hose lock button, then
►
►
Screw the quick
►
Serious damage could
►
Unlock trigger (by
►
Check if water leaks from joints;
►
Connect to power
►
This will reduce
Whilst the
►
Insert
►
Push and turn
Turn on
►
