Idiomas disponibles
Idiomas disponibles
SETUP PROCESS
Both the transmitter and the receiver have an ON / OFF selector, USB port and "SET" button.
The ON / OFF selector allows you to turn the unit on or off.
The USB port allows you to charge the batteries if you use rechargeable batteries.
ATTENTION: Be sure to use the correct type of batteries if you connect a charging cable, using non-
rechargeable batteries and connecting the charger may damage the product or cause injury.
The red LED will start flashing when the batteries are almost empty. When using rechargeable batteries,
this LED will be on while charging, and flashing when finished.
The SET button allows you to select the frequency.
FREQUENCY SELECTION
1. Place the batteries in both the receiver and transmitter and turn them on. The blue LED on the receiver
will start flashing, stopping when paired with the emitter (same frequency channel). By default, the
system is set on channel 1.
2. If the flashing does not disappear, it means that both devices are on different channels. Press the SET
button on the receiver for two seconds, this will reset channel 1. Make the same step on the transmitter
by pressing the SET button for two seconds. In this case, both devices will reset to channel 1 and, after a
few seconds, they will link, stopping the LEDs to flash.
3. If you want the system to use channel 2, press the SET button once and repeat the step on the transmitter
to synchronize them.
4. Similarly, if you want them to be on channel 5 they would have to press the SET button 4 times from the
initial position of broadcast channel 1.
This device accept normal batteries and rechargeable batteries using thwe microUSB port to recharge them.
PLEASE, check the type of inserted batteries before connect the USB cable to an external power supply. In that case,
USE ONLY RECHARGEABLE BATTERIES. Using normal batteries during recharge process could cause damage in the
product and the people.
WARNING !!!
