Uline H-9764 Manual De Instrucciones página 2

2. Align armrest with holes on bottom of seat cushion.
Use three M6 x 30 mm screws to attach. Repeat on
opposite side. (See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
Figure 2
3. Align mechanism with holes on bottom of seat
cushion. Use four M8 x 20 mm screws to attach.
(See Figure 3)
Figure 3
PAGE 2 OF 9
ASSEMBLY CONTINUED
M6 x 30 mm
Screw
M8 x 20 mm
Screw
4. Position back support in slot between bottom of
seat cushion and mechanism. Align holes and use
four M8 x 20 mm screws to attach back support to
mechanism. (See Figure 4)
Figure 4
5. Slowly lower chair assembly onto the gas lift. Press
down on seat cushion to secure in place.
(See Figure 5)
Figure 5
M8 x 20 mm
Screw
0522 IH-9764