Redroad G10 Manual De Instrucciones página 14

Operation
Global cleaning
When no map is stored, if global cleaning is choose, the main machine
will start cleaning each zone by a square area of 6m×6m. When any
map is stored, if global cleaning is choose, the main machine will start
cleaning each room along the planned route. Upon completion of
cleaning, the main machine will return to cleaning station.
Edge cleaning
When choosing edge cleaning in the App, the main machine will
automatically recognize range of the area to clean, and start cleaning
along edge, and return to cleaning station automatically after finishing
cleaning.
Specified-area cleaning
When an area to be cleaned is defined in App, the main machine will
clean the defined area.
Note: During cleaning, the main machine may go beyond a defined
area, so be sure to remove any obstacle on the floor within defined
area since definition of any area will not ensure safe separation.
Fixed-point cleaning
When choosing fixed-point cleaning and choose a target point in App,
the main machine will route cleaning task and start cleaning within a
rectangular area of 2m × 2m based on the target position defined in the
map in App.
Carpet identification
After the carpet is identified in the cleaning process of the sweeping
and mopping robot, the suction enhancement will be automatically
turned on and the mop is lifted, and this function can be turned off by
using App; or turn on the carpet avoidance function in the App, and the
sweeping and mopping robot will automatically bypass the carpet for
cleaning.
Note: For children's floor mats, yoga mats, sponge mats and hard
short-haired carpets, there may be misjudgments, which will not affect
the normal use. Virtual walls/forbidden zones can be set to prohibit the
main machine from entering areas that do not need cleaning.
Non-Disturbance mode
When non-disturbance mode is activated, proceeding at breakout point,
scheduled cleaning and active voice reporting are unavailable for the
vacuum-mop. Non-disturbance mode is activated by default during the
period from 22:00 to 7:00. Non-disturbance mode can be deactivated in
APP.
Sleep
Unless during charging, the main machine will go to sleep automatically
when it is left idle for 5 minutes; it will be powered off automatically
when it has slept for 6 hours without appointment. In sleep status, press
any button or App will wake main machine up.
Note: Main machine will not go to sleep on the cleaning station.
11