Using The Chopper Attachment - ARIETE 898/1 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37
ATTENTION:
Before removing the motor body (D), allows the blade to stop completely and then unplug
the appliance.
- Rotate the hand blender shaft (G) or the wire whisk (H) or the potato masher (L) to remove it.
WARNING
In case the appliance does not work, check the attachments are properly inserted.
Do not use the potato masher with solid or raw food to avoid damaging the blade.
Do not use the appliance in a saucepan in contact with heat sources.
Always remove the saucepan from the heat source, place is on a stable flat surface and allow
it to cool down.
For a thin, smooth ground, if necessary, remove food from the side of the container and bring
it to the centre using an apposite spatula.

USING THE CHOPPER ATTACHMENT

- Mount the blade (P) on the shaft (N) of the goblet (O) (Fig. 5).
ATTENTION:
Handle blades with care to prevent injury.
INSERT THE BLADE BEFORE FOOD TO BE CHOPPED. Before removing the lid, wait for the
blade to stop completely.
- Cut food into small pieces (1.5 x 1.5 cm) and insert it into the goblet (O).
- Fit the lid (Q) on the goblet (O) and rotate clockwise until it completely locks, (Fig. 6). Make sure
the upper part of the blade (P) is properly inserted in the apposite housing on the lid base.
ATTENTION:
Before using the appliance, make sure the blades and the lid are properly mounted.
- Place the motor body (D) on the lid (Q). Align the symbol of the "open lock" on the lid with the arrow
on the motor body and rotate the latter clockwise until it clicks in place (Fig. 7).
- Assemble the appliance and start it by pressing the minimum speed button (B). Only after few
seconds, according to preparation and kind of food, it is possible to increase the speed by pressing
the relevant top dial (A).
According to use, it is possible to set also the max speed "Turbo" by pressing the apposite button
(C).
The best performance of the appliance is achieved through a pulse mode by pressing the button
(B-C) for a very short time (2-3 seconds).
ATTENTION:
In case the appliance does not work, check the attachments are properly inserted.
- For a thin, smooth mix, if necessary, remove food from the side of the goblet (O) and bring it to the
centre using an apposite spatula, after having removed the motor body (D) and the lid (Q).
- To interrupt the operation, just release the speed button pressed (B-C). The appliance allows to
chop food in very short time.
- 15 -
EN
Tabla de contenido
loading

Tabla de contenido