General Operation - Mac allister MPWP1800-3 Manual Del Usuario

Product functions / Operation
EN EN
Automatic motor start-stop device
The automatic motor start-stop device is operated by the trigger (8h) of the spray
gun (8). When the trigger (8h) is released the dynamic pressure automatically
cuts out the motor. When the trigger (8h) is depressed the automatic drop in
pressure starts the motor and the pressure is restored after a very slight delay.

General operation

> Check the product, its power cord and plug as well as accessories for damage
before each use. Do not use the product if it is damaged or shows wear.
> Double check that the accessories and attachments are properly fixed
> Always hold the spray gun by its handle and gripping surface. Keep the handle
and gripping surface dry and free from lubricant to ensure safe support.
> Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
> Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete stop
before averting.
> Do not overwork yourself. Take regular breaks to ensure you can concentrate
on the work and have full control over the product.
Operation
WARNING! Do not operate the product with a closed water tap! This
leads to dry running and subsequently damages the product!
Kickback forces result from squeezing the trigger! Therefore, always
hold the spray gun with both hands!
Pay attention to safe posture! Improper handling can lead to injuries!
WARNING! Do not operate the product when the ambient
temperature is below 0 °C. Water will freeze inside the product and
damage it.
> Connect the product to water supply as described.
> Turn on the water tap fully.
> Hold the spray gun (8) with both hands.
> Direct the nozzle away from yourself towards the surface to be cleaned
(Fig. 16).
24
MNL_MPWP1800-3_MAC_GB_V6_200527.indd 24
MPWP1800-3 by MacAllister
5/27/20 5:54 PM