Aprimatic PLUS SC6 WIRELESS Guia De Inicio Rapido página 5

GB
DIAGRAM A
M/S in First Input
COMPONENTS
J7 Power supply and output terminal board
SW1 Button for saving/deleting the SC6 wireless
key selector
DL1 (green) This LED flashes to indicate that
the power supply is on.
It flashes in two ways to indicate whether or not
an SC6 wireless selector is stored in the receiver
memory:
- fast flashing = memory empty
- slow flashing = selector stored.
BZ1 This is a buzzer providing confirmation of
commands from the SC6 wireless: the
audible signal confirms that the command
given using the SC6 wireless selector has
been received.
Note: The buzzer may be disabled (see JP4)
JP4 Jumper for enabling the buzzer BZ1
- JP4 closed = buzzer enabled
- JP4 open = buzzer disabled
brown
grey
red
white
green
blue
yellow
red
SW2 Button for saving/deleting the remote
DL2 Red LED for remote controls
JP
- IMPORTANT. Keep JP closed!
JP1
- JP1 closed = contact connected to negative
Note. With JP1closed, make the connection
using a 3-core cable as shown in DIAGRAM A
(terminal No. 4 remains free).
- JP1 open = clean contact *
*CAUTION. For connection with a clean contact,
make the connection using a 4-core cable as
shown in the diagram below (terminal No. 4
should also be connected).
ANTENNA
controls
Jumper for remote controls on channel 1
Jumper used to disconnect the relay
contact from GND (to make a clean
contact)
terminal
5/16