Additional Safety Instructions - Dexter 450ETC1 Manual De Instrucciones

2.2 ADDITIONAL SAFETY INSTRUCTIONS

• Ensure that the directional arrow on the cutting disc imatches the directional arrow on the machine
(the motor's rotating direction).
• No other people should be in the immediate vicinity of the machine when you are using it. Bystanders
must be kept at an appropriate safe distance.
• Never run the power cord over the machine table!
• Never cut "free hand". The workpiece must always be stable
workpiece must always be pressed tightly up against the fence.
• Never cut workpieces which are so small that they cannot be safely pressed against the fence and
could be twisted.
• Never cut workpieces which are so small that they can't be held at a safe distance from the cutting
disc.
• Always cut only one work piece. Never cut several workpieces at the same time. Workpieces should
never be laid behind one another or on top of one another. There is a danger of jamming and being
• Make sure that the workpiece cannot slip or get jammed in the cutting disc while it is being cut.
machine is at a complete standstill.
should be no foreign bodies on the workpiece or the machine table. Cut tile parts can get caught in
• Never reomove any cut parts, if the machine is switched on. Risk of cuts!
• Cut workpieces can have sharp cutting edges. Careful, you may cut yourself!
• Unplug the machine, if you are leaving it unattended.
• Only use clean water without any additives as coolant.
• Never expose the machine to the elements for an unnecessarily long period of time.
• If the replacement of the supply cord is necessary, this has to be done by the manufacturer or his
agent in order to avoid a safety hazard.
• Keep water clear of the electrical parts of the tool and away from persons in the working area.
• Never use a cutting blade rated with a blade speed lower than the machine.
RESIDUAL RISKS
Even if you operate this power tool according to the instructions residual risks will always remain.
The following risks may arise dut to the design and constrction of this power tool:
• Damage to health resulting from hand-arm vibrations if the power tool is used for a long period of
time or is not used or maintained properly.
• Injuries and material damage caused by loose tool attachments which, because of sudden damage,
WARNING !
implants under certain circumstances.
To reduce the risk of serious or fatal injuries we recommend that
people with medical implants consult their doctor and the
manufacturer of the medical implant before operating the power
tool.
112
FR
ES
PT
IT
EL
PL
UA
RO
EN