Trust ACDB-8000BC Manual Del Usuario página 8

EN
ACDB-8000BC TRANSMITTER + PLUG-IN DOORBELL
Components
A
LED indicator doorbell
B
Pair button
C
Volume button
D
Melody button
E
Battery holder (including 12V A23 alkaline battery)
F
Switch wires
G Terminal block
H
Adhesive strips and screws
Wireless control
This wireless doorbell can be operated wirelessly with
a minimum of 1 and a maximum of 32 Trust Smart
Home transmitters of your choice. This way you can
play a desired melody using the supplied transmitter.
In addition, you can also have a melody play when
movement is detected (via a wireless motion detector)
and/or when a window or door is opened (via the wireless
door/window contact).
You can set a separate melody for each Trust Smart Home
transmitter, for example when someone presses the
existing push button or when a door or window is opened.
1A. Transmitter installation
A
Always switch off the mains voltage (in the meter
box) before you start disconnecting the existing bell
installation.
B
Follow the wires from your existing doorbell push
button that usually lead to your meter box, and
disconnect it from the current installation (usually
a transformer). Your existing bell installation will not
work anymore as a result.
C
Turn the power back on before continuing with the
installation. Make sure there is no more exposed wiring.
8
1B.
A
Press the clamps of the terminal block. Then insert the
push button transmitter wires into the terminal block
inputs (L+N).
B
Press the clamps of the terminal block. Then insert
the wires from the existing doorbell push button into
the remaining terminals of the terminal block (L+N).
2. Place receiver
Plug the doorbell into an indoor socket outlet. If you move
the doorbell to a different socket, the paired transmitters
will remain in the memory.
3. Select desired volume
First press the volume button to set the desired volume
level. There are 4 levels: High, Medium, Low and Disabled
(LED indication only).
4. Select desired melody
Then press the melody button to select 1 of the 6 melodies.
You can set a separate melody for each transmitter
(push button, motion detector, door/window sensor)
by selecting it beforehand.
5A. Pair transmitter(s) to the doorbell
Do not press the pair button for more than 1 second to
activate the learning mode.
The learning mode will be active for 10 seconds and the
LED indicator on the doorbell will flash slowly.
5B
Send an ON signal while the LED indicator is flashing by
pressing your existing doorbell or with another Trust Smart
Home transmitter to pair it.