Heltun HE-FT01 Guia De Inicio Rapido página 11

Including the HE-FT01 to an Existing Z-Wave Network
To add the HE-FT01 to an existing Z-Wave network (i.e. "inclusion"), do the following:
1.
Enter "SETTINGS" Mode by pressing and holding the Climate
2. Scroll menu to "Parameter 2 – nEt" using the "SPEED" button to scroll up, and the "MODE" button to scroll down.
3. The current state of the network will display in the Parameter Value position (bottom left corner). It should display "EcL".
Note: If "InC" is displayed, the HE-FT01 must rst be Excluded from an existing Z-Wave network (see "Exclusion" below).
4.
Start the Inclusion Mode from the gateway/controller.
5.
On the HE-FT01 in Parameter 2, press the Plus "+" key to start the Inclusion process.
6.
Note that lines will be moving in the Parameter value position (bottom left corner).
7.
The Antenna with signal strength bars icon
8.
If only the Antenna icon
steps 4-7).
Removing the HE-FT01 from Z-Wave network
To remove the HE-FT01 from a Z-Wave network (i.e. "Exclusion"), do the following:
1.
Enter "SETTINGS" Mode by pressing and holding the Climate
2.
Scroll menu to "Parameter 2 – nEt" using the "SPEED" button to scroll up, and the "MODE" button to scroll down.
3.
The current state of the network will be displayed in the Parameter Value position (bottom left corner). It should display: "InC".
Note: If "EcL" is displayed, the HE-FT01 is already Excluded.
4.
Start the Exclusion Mode from the gateway/controller.
5. Press the Minus "–" button in the HE-FT01 Parameter 2 to start the Exclusion process.
6. Note that lines will be moving in the Parameter value position (bottom left corner).
7.
The Antenna icon should appear in the bottom right corner and "EcL" in the value position if the Exclusion was successful.
8.
If the Antenna with signal strength bars
Note: If the HE-FT01 has previously been part of a Z-Wave network and not Excluded since, Inclusion is not possible without rst
performing an Exclusion or Factory Reset procedure.
Note: If the HE-FT01 is included in the Z-Wave network the Antenna icon will appear in the bottom right corner of the main screen with
signal strength bars .
should appear at the bottom right corner if Inclusion was successful.
or "Err" is displayed in the Value position, the HE-FT01 Inclusion was not successful (try repeating
icon or "InC" in value position are displayed, repeat the Exclusion process.
button for three seconds.
button for three seconds.