Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3 LUX when set to "moon" (minimum) position. As for the parental
setting, please refer to the test pattern.
▶ When the sensor identifies a person, the light's running time will be
activated, if it identifies another person, the running time is reset.
▶ Adjustable timer: the delay time could be set according to
customers' requirements, the minimum time of this item is
10sec±3sec, and the maximum time is 5min±1min..
Low sensitivity
TEST
▶ Turn the TIME knob counterclockwise to the minimum. Turn the LUX
knob clockwise to the maximum (sun).
▶ Light; the lamp will not have the signal at the beginning. After 30
seconds of warm-up, the lamp starts to work. If the induction signal
is received, the lamp turns on. Although there is no other induction
signal, the lamp should stop working within 10 sec ± 3 seconds.
▶ Turn LUX counterclockwise to minimum (moon). If the ambient light
is more than 3 LUX, the lamp will not work. If the light is less than
3 LUX (dark), the sensor could work. Under no condition of induction
signal, the lamp should stop working within 10 sec ± 3 seconds.
Note
▶ When do day test, please turn the knob to LUX (SUN) position,
otherwise the lamp sensor will not work!
▶It must be installed by an electrician or qualified personnel.
▶Avoid installing it on uneven surfaces.
▶There should be no obstacles and moving objects in front of the
sensor as it could affect the detection.
▶Avoid installing it near areas of temperature alteration, air, such as
air conditioning, central heating, etc.
▶Considering your safety, please do not open the cover after
installation..
Instruction manual
PROBLEMS AND SOLUTIONS
IF IT DOES NOT WORK
▶ Por favor, compruebe si la conexión de cables de potencia y de
▶ Por favor, compruebe si la carga es buena.
High sensitivity
▶ Por favor, compruebe si los juegos de luces corresponden a la luz
SENSITIVITY IS POOR
▶ Please check whether there is any obstacle in front of the detection
▶ Please check if the ambient temperature is too high.
▶ Please check whether the induction signal source is in the detection
▶ Please check if the height corresponds to the height indicated in
▶ Please check if the sensor has the correct orientation.
THE SENSOR CANNOT AUTOMATICALLY SWITCH OFF
▶ Please check if there is continuous signal in the detection field.
▶ Please check if the time delay is the longest.
▶ Please check if the electrical current corresponds to that indicated
13
carga es correcta.
de la habitación.
sensor that may affect the signal.
fields.
the instructions.
in the instructions.
ref. 32507
ES
PT
EN
FR
Tabla de contenido
