Assemble The Shaft; Use The Shoulder Strap; Operation; Operation Tips - Cramer A48T10BC-CR Manual

1. Pull carrying ring apart and place over the power head
end of shaft; position near the power head.
2. Install bolt and lock nut.
3. Tighten nut securely.
Check for tightness before each use to avoid serious injury
or product damage.
3.5

ASSEMBLE THE SHAFT

Figure 6.
1. Loosen the knob on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole and
move the two shafts towards each other.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the knob.
3.6

USE THE SHOULDER STRAP

Figure 7.
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
4

OPERATION

IMPORTANT
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
WARNING
Be careful when you operate the machine.
4.1

OPERATION TIPS

Figure 8.
WARNING
Keep clearance between the body and the machine.
WARNING
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
• Keep the machine connected to the correctly worn
harness.
• Keep a firm hold with two hands on the machine while
you operate the machine.
• Cut tall grass from the top down.
NOTE
English
If grass winds around the trimmer head:
• Remove the battery pack.
• Remove the grass.
4.2

CUTTING TIPS

Figure 8.
• Tilt the machine toward the area to be cut. Use the tip of
the cutting line to cut grass.
• Move the machine from right to left to prevent thrown
debris towards the operator.
• Do not cut in dangerous areas.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences can cause breakage. Stone and
brick walls, curbs, and wood can damage the blade.
5

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Check
regularly that the handles are firmly mounted.
Use only the replacement parts and accessories of the initial
manufacturer.
5.1

GENERAL INFORMATION

Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in a cool and dry place.
• Use correct clothing, protective gloves and safety glasses.
5.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth dipped in
neutral detergent.
• Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or excessive
grease.
5
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
EN