H - Troubleshooting; Possible Problems - Campingaz 360 Grill Instrucciones De Empleo

Ocultar thumbs Ver también para 360 Grill:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
G - MAINTENANCE - STORAGE
If you take care of your appliance properly, you will be able to enjoy using it for many years.
• Do not clean your appliance when it is being used. Wait until it has cooled down to avoid burns caused by hot parts (griddle,
grid, pan support, reservoir etc.).
• Once the unit is cold (approximately 15 minutes) remove the cooking plate and pan support. Unlock the water tank from the
base. Empty the water.
• Clean greasy parts with soap and water or a non-abrasive detergent product.
• To simplify cleaning, the lid, the cooking plate, the water tank and pan support can be washed in a dishwasher. You can wash
the plastic base with a sponge.
• When cleaning, be careful to avoid clogging the burner holes. If the holes are clogged, for example by food that has spilled
over, open them with a non-metal brush.
• After cleaning, assemble the pieces of the unit, put the lid back on and lock it thanks to the clips.
• The unit should be stored in a safe, secure, and dry place, out of the reach of children and never in a cellar.
• If the device has not been used for 30 days, check to see that cobwebs are not clogging the burner hose openings; this could
lead to decreased burner efficiency or to a dangerous ignition of gas outside the burner.
• If the appliance will not be used for a long period of time, disconnect the cylinder as indicated in section F.
• Regularly check the condition of the hose and change it if it shows signs of ageing or cracking (see section C).
• Store your appliance in the bag (12). This bag allows you to carry your appliance easily or to store it away from dust.

H - TROUBLESHOOTING

In case of burn back (ignition under the burner cap) switch the product off, allow it to cool down (approximately five
minutes), then reignite the appliance. If the problem of burn back persists, then please contact your local Campingaz
representative.

Possible problems

The burner does not light up
The burner does not burn smoothly or goes out
Unstable blowing flames
Large plume of flame on the burner surface
Flame at the injector
Burning leak around a union
Insufficient heat
Burning leak behind the adjustment knob
Probable causes / Corrective action
• Poor gas supply
• Regulator not operating properly
• Pipe, valve, venturi tube or burner holes obstructed. Clean the venturi.
• Check that gas is present
• Check the pipe connection
• Contact your servicing agent.
• New cylinder may contain air. Allow the appliance to operate and the fault
will clear itself
• Presence of residual water after cleaning of the burner or filling/emptying
of the tank. Allow the appliance to operate and the fault will clear itself.
• Contact your servicing agent.
• The venturi is obstructed (possibly cobwebs)
• Contact your servicing agent.
• The cylinder is almost empty
• Change the cylinder and the fault will clear itself
• Contact your servicing agent.
• Shut off the gas supply immediately
• Leaking union: tighten nuts or change pipe
• Contact your servicing agent.
• Injector or venturi tube obstructed. Clean the venturi.
• Contact your servicing agent.
• Defective valve
• Shut down the stove
• Contact your servicing agent.
21
®
GB
Tabla de contenido
loading

Tabla de contenido