Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Maintenance
m
WARNING!
To avoid serious personal injury, always
remove the battery pack from the tool when cleaning or
performing any maintenance.
m
WARNING!
When servicing, use only identical
replacement parts. Use of any other parts may create a hazard
or cause product damage.
Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use clean cloths
to remove dirt, dust, oil, grease, etc.
m
WARNING!
Do not at any time let brake fluids, gasoline,
penetrating oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken, or destroy plastic which may
result in serious personal injury.
Draining the Tank
If there is any liquid left in the tank after spraying, the tank
should be drained before cleaning. Do not store chemicals in
the tank.
1. Make sure the battery is removed.
2. Release the tank latches on both sides, and lift up the
motor housing from the tank (Fig. 15).
Fig. 15
Motor
housing
Tank
3. Unscrew the measuring cup and drain the tank thoroughly.
m
WARNING!
Always store and dispose of chemicals
properly. Disposal of contaminated rinse water should be
performed according to local ordinances and by laws.
Clean the Tank
1. Fill the tank about one-third full with clean water. For a
better clean result, use a small amount of mild household
detergent.
NOTE: Never use flammable chemicals or abrasive
cleaning agents to clean the tank.
2. Reattach the clean tank to the motor housing. Flip up the
tank latches to lock the tank in place.
3. Insert the battery pack. Spray until the tank has been
emptied. Make sure to direct the spray toward an area that
will not be damaged by the spray solution.
4. Repeat the procedure with clean water. If needed, rinse
the tank again, then drain again as directed above.
5. Wipe the outside of the tank with a clean, dry cloth.
Remove the battery. Air dry the tank and all parts of the
unit before storing.
NOTE: To avoid any leaking, make sure to lock the latches
on both sides at the same time when assembling the tank.
Clean the Nozzle
During longtime use, the nozzle may become clogged. Follow
the instructions below to clean clogged nozzle.
1. Turn off the unit and remove the battery.
2. Unscrew and remove the nozzle from the spray wand
(Fig. 16).
Fig. 16
3. Push a narrow string through the cross holes to clear any
debris (Fig. 17). If necessary, rinse the cross holes and
nozzle with clean water.
Fig. 17
Tank latch (on
both sides)
4. Wipe the nozzle and cross holes with a clean dry cloth and
reinstall the nozzle.
13
Cross hole
Tabla de contenido
