Waldbeck Clearflow 18 Manual De Instrucciones página 18

EN
18
Install the unit as shown in figure 4. Attention: The curved tube (7) with the
4
spray tube (9) is intended for the filter outlet! The other curved pipe (13) is
intended for the filter inlet together with the skimmer.
Press the blue button down firmly and release it again immediately. When it
comes back, it draws water into the pump (if all hoses and parts are properly
5
and tightly connected). As soon as the water level in the outlet pipe/hose
corresponds to that of the aquarium, you can connect the unit to your house
electricity.
6
Under the transparent cover you will find the on/off switch.
Change the illuminant
• Carefully lift the lid and place it upside down.
• Loosen the screw and remove the frame of the quartz cylinder.
• Slowly and carefully turn the cylinder anticlockwise and carefully remove
it.
• Pull out the old fluorescent tube and replace it with a new one.
• Be sure to use an identical model.