Tabla de contenido
Idiomas disponibles
Idiomas disponibles
STEP 5
1. Insert 4 wooden dowels (G) into holes on lower rear cross bar (8).
2. Attach 1 lower left side frame (5) to bottom board (3) and lower rear cross bar (8) by
inserting wooden dowels (G) into holes on lower left side frame (5) and inserting 3 screws
(A) through holes on lower left side frame (5), then tighten to 2 cross bars (7) on bottom
board (3) and lower rear cross bar (8) with Allen wrench (F).
3. Repeat above steps to assemble lower right side frame (9) to 2 cross bars (7) on bottom
board (3) and lower rear cross bar (8).
STEP 6
1. Press 14 plastic caps (E) into screw holes on both upper side frames (2) and both lower
side frames (5).
*Tip: If added pressure is needed to keep plastic caps in place – cover caps with a piece of paper and tap
lightly with hammer to secure cap.
Tabla de contenido
