Tabla de contenido
Troubleshooting
Problem
Cause
The motor does not
• There is no power.
start .
• The impeller is stuck.
The motor turns but is
• The foot valve filter is clogged.
not pumping water.
• Excessive suction height.
• Air in the inlet.
Insufficient flow speed.
• Suction height is in the limit.
• Foot valve filter partially clogged.
The overload thermal
• The motor is overheated.
protector is in
• The impeller is stuck.
operation.
Solution
• Check connections and voltage values.
• Remove the fan cover and turn the shaft to release it.
• Clean the filter.
• Shorten the suction pipe length.
• Check the suction pipe is hermetic. Assure the foot-valve is
submerged at least 20". Purge again the pump (see page 8).
Check the suction height
.
• Shorten the suction pipe length.
• Clean the foot valve and the full suction pipe if necessary.
• Check tension and ventilation.
• Remove the fan cover and rotate the motor shaft to free it.
9
ENGLISH
Tabla de contenido
