WERKU WK402020 Instrucciones Originales página 4

ENG ORIGINAL INSTRUCTIONS
inhaling these substances or allowing them to come
into contact with your skin. Use PPE designed to
prevent and protect against incidents of this kind.
DESCRIPTION OF THE PRODUCT.
The dry-wet vacuum cleaner has been designed to
carry out jobs of dry or wet vacuum cleaning. Refer
to this plan to familiarize yourself with the dry-wet
vacuum cleaner before use.
1
5
2
4
1. Switch.
2. Container latches.
3. Dust container.
4. Transport wheels.
5. Auxiliary plug.
6. Brush.
USE INSTRUCTIONS.
Before starting up the dry-wet vacuum cleaner,
we recommend that you carefully read all the
instructions as indicated. Please respect all
regulations regarding the prevention of accidents,
health and safety directives, laws and applicable
restrictions for work places. The dry-wet vacuum
cleaner must only be used by persons who have
been instructed in its use and only for the purposes
for which it has been designed.
POWER SUPPLY.
Make sure the power supply is adapted to the
requirements shown on the information panel of
the dry-wet vacuum cleaner (1). Using the motor
at low voltage will make it operate slowly. This will
reduce performance and may cause the motor to
overheat.
EXTENSION CORD.
If the working area is at some distance from the
power supply, use an extension cord of enough
diameter and quality.
FITTING THE WHEELS.
Disconnect the vacuum cleaner from the mains.
Open the container latches on either side of the
vacuum cleaner and remove the motor unit (2).
Turn the dust container upside down on a stable
surface (3). Insert the wheels into the four holes
provided (4). The wheels are held in place by
friction, no additional fixings are required.
DUST BAG FITTING-REMOVING.
2
The dust bag is only for use when dry vacuuming
and must be removed before wet vacuuming.
Disconnect the vacuum cleaner from the mains.
Open the container latches on either side of the
3
vacuum cleaner and remove the motor unit (2).
Slide the dust bag gently over the socket in the
dust container. Take care not to damage the dust
bag (5). The dust bag is held in place by the ring
around the opening. The dust bag should fit as
6
closely as possible to the wall of the dust container
(6). To remove the dust bag, gently slide it off the
socket in the dust container. Replace the motor
unit and fasten the container latches.
FULL DUST BAG.
Once the dust bag is full performance drops
noticeably.
immediately and proceed to replace the dust bag.
Disconnect the vacuum cleaner from the mains.
Open the container latches on either side of the
vacuum clean and remove the motor unit (2). Slide
the full dust bag off the socket on the inside of the
dust container and empty it (5). Fit again the dust
bag to the socket. Replace the motor unit and fasten
the latches.
FITTING THE FILTERS.
Attention! Never use the wet and dry vacuum
cleaner without a filter. Check that the filter is
securely fitted at all times. Disconnect the vacuum
cleaner from the mains. Ensure that the filter is
clean and dry. Open the container latches on
4
English
Switch off the vacuum cleaner