Venga VG CCG 1006 Manual De Instrucciones página 10

Problem
The appliance
does not work.
Water leaks out
of the
appliance.
The appliance
produces a lot
of noise during
working.
Coffee grounds
enter into the
jug.
Brewing
coffee
takes
The coffee
longer
maker
than
switches off
usual.
before the
water tank
is empty.
Problem
Coffee grounds
enter into the
jug.
The coffee does
not taste good.
The coffee is not
hot enough.
The jug is
difficult to
place in the
appliance or
remove from
the appliance.
VG CCG 1006
Make sure the voltage indicated on the appliance corresponds
to the local mains voltage.
Make sure the appliance has been plugged in & switched on.
Check if the water tank is filled beyond the MAX level.
Make sure the water tank is not filled with hot water.
Make sure the appliance stands steadily on a stable, flat surface.
The appliance needs to be descaled (see chapter 'Cleaning
Mineral Deposit').
Either the jug has not been placed correctly under the grind &
brew basket.
Or you removed the jug for more than 30 seconds during
brewing.
The appliance needs to be descaled (see chapter 'Cleaning
Mineral Deposit').
The appliance needs to be descaled (see chapter 'Cleaning
Mineral Deposit').
Or the jug has not been placed correctly under the grind & brew
basket.
Or you removed the jug for more than 30 seconds during
brewing.
Check if you leave the jug with coffee on the warm plate too
long, especially if it only contains a small amount of coffee.
Check if the brewed coffee is too little. The coffee will warm
longer if you brew more.
Make sure you place the jug properly on the warm plate.
Make sure the lid of the jug & filter basket are in right position.
Tilt the jug a little to place or remove it. Be careful not to spill the
hot coffee to avoid scaling.
Solution
Solution
10