Venga VG HCR 3001 Manual De Instrucciones página 6

OPERATION
•
Select the accessory according to the desired hair style.
• Install the desired accessory on the air outlet of the appliance. You should hear a
"click" when it is locked in.
•
Press the On/Off button to start or stop using the appliance.
• Remove the accessory from the air outlet by pressing the accessory unlock button
and gently pulling the accessory out at the same time.
Hair drying
•
Select the hair drying or the half brush accessory.
•
Use the appliance on wet hair.
•
Maintain a 5-10cm distance between the appliance hot air outlet and your hair to
avoid any damages.
Hair straightening
•
Select the hair straightening accessory.
•
Use on dry and untangled hair.
•
Position the appliance as closely as possible to the roots and take a section of
approximatively 3-5cm into the pliers.
• Slowly glide the hair straightener from the roots to the ends. When you get to the
ends, turn the hair straightener in a half-circle inward (or outward).
•
Repeat this process several times if necessary in order to obtain an optimal result.
• To give more volume to your hair, use an upward motion to lift the roots from the
scalp when the appliance is close to the roots, i.e. at the beginning of the
straightening process.
Hair curling
•
Select one of the round brushes accessory.
•
Position the appliance as closely as possible to the roots and take a section of
approximately 3-5cm wide.
• Wrap gently the section around the brush.
•
Curl under the heat for between 5 and 10 seconds depending on your hair strength.
•
Release the section by untangling the section of hair out of the brush.
Notes :
−
Don't use the appliance without accessory locked on.
−
Never use this appliance on synthetic hair or wigs.
−
Should the hair dryer stop working for any reason, turn it off at once and let it cool
down.
−
Always ensure the switch is set to OFF position before (un)plugging the unit.
VG HCR 3001 6