Product Use - Star 148179 Guia De Inicio Rapido

PRODUCT USE

This utility pump will not turn by hand. This kit is designed to be used with electric hand drills. It is
self-priming and can develop pressures to 25 PSI and flow rates to 150 GPH.
This pump is ideal for the following applications:
• Clogged sinks
• Overflowing washing machines
• Emptying aquariums
• Pumping out pool covers
• Transferring oil from autos and boats
INSTRUCTIONS
For using the drill pump with included attachments.
(This drill pump may also be used with standard garden hoses connected to the inlet and outlet sides
of the pump. NOTE: Be sure rubber washers are in place when using garden hoses).
1. Attach the plastic barbed hose adapters (2) to the
inlet and outlet sides of the drill pump.
NOTE: Be sure rubber washers are in place and air
tight. Failure to use washers may result in reduced
pressure and failure to pump.
2. Slip the rubber boot hose connector over the exposed
inlet end of the plastic barbed hose adapter. Insert the
1/4" plastic suction tube into the rubber boot on the
inlet end of the drill pump. (Inlet and outlet are clearly
marked on the pump face).
NOTE: The inlet hose should be as short as possible
and no more than 25'.
NOTE: Be sure to use the small 1/4" pastic suction
tube when transferring oil.
3. Securely slide the 1/2" plastic hose (larger size) over
the barbed end of the hose adapter on the outlet side.
NOTE: Ensure that both hoses are free of kinks or
obstructions.
NOTE: The discharge hose should be less than 50'.
4. Tighten the drill chuck onto the pump shaft.
Plug in the 1300RPM or stronger drill. If using a
cordless drill be sure to use a fully charged battery.
With the pump/hose assembly loosely held with one
hand and the drill with the other, slowly start the drill
to ensure it is rotating in the proper direction. (see
arrow on the pump housing).
FLOW
IN OUT
ROTATION
3
1
2
3
4
IL2619