Trust ZWLD-100 Manual De Usuario página 5

LED FUNCTION TABLE
Connection mode
Connected successfully
Water detected
Detector reset
5. MOUNT THE DETECTOR
A
Remove the plastic layer
from the double sided-tape
on the back of the detector
and place it on a flat service
on the wall in a place with a
risk of leakage.
B
Remove the plastic layer
from the double sided-tape
on the white sensor at the
end of the cable and place it
firmly on the floor.
ZWLD-100 WATER LEAKAGE DETECTOR EN ZWLD-100 WATER LEAKAGE DETECTOR EN
LED will flash fast for approximately 1 min.
LED will light up for 3 sec (The App will also
indicate when the connection is successful)
Red LED will light up once (The App will also
indicate when water is detected)
LED will flash 6x
RESET DETECTOR AND
ACTIVATE CONNECT MODE
Warning: This step will
disconnect the detector from
the Smart Bridge or the ICS-
2000. To reset the detector
press the button in the hole
at the side for approximately 5
sec with the included pin. The
LED will flash 6x to confirm
the reset.
5