Storage; Indication And Control - Orvaldi i600 LCD USB Manual De Usuario

5.3 DC Start
Press on main switch for 4 seconds when city utility is black out, UPS will be turned on and then go to
back up mode. To turn off UPS, please press main switch for 4 seconds again. If users want to turn on
UPS again, please wait for 10 seconds to press main switch for 4 seconds again.
5.4 When UPS is under battery mode and battery voltage is too high or low, buzzer will beep.
5.5 Buzzer will beep twice every 8 seconds when city utility is black out. To silence alarm, please simply
press main switch. To re-start alarm, please press main switch again.

STORAGE

To ensure battery lifetime, please kindly read and also follow below instruction completely.
This unit is shipped from the factory with its internal battery fully charged, however, some charge
maybe lost during shipping and the battery should be recharged prior to use. Plug the unit into an
appropriate power supply and allow the UPS to charge fully by leaving it plugged in for at least 10 hours
Extended Storage:
Storage Temperature Recharge Frequency
5 to 86°F (-15 to 30°C) Every 6 month
86 to 113°F (30 to 45°C) Every month

INDICATION AND CONTROL

LED version:
Back-up Mode Table
Status Back-up LED (Yellow)
Battery LED is ON when UPS is
normal & on Battery mode ; LED
Load normal flash twice every 4
seconds when battery
and load is normal.
Low battery LED flash 4 times
every second.
AC Mode Table
Status Back-up LED (Yellow)
Battery fully LED is OFF
charged
Battery
70-90%
charged
Battery
50-70%
charged
Battery
30-50%
charged
Battery
0-30%
charged
Charging Duration
10 hours
10 hours
On-line LED Cut-off LED (Red) Buzzer
(Green)
LED is OFF Depends on fault Beeps twice
condition every 8 seconds
Beeps 4 times
every second
On-line LED Cut-off LED (Red) Buzzer
(Green)
LED is ON Depends on fault Buzzer is OFF
condition
LED flash once
every 8
seconds
LED flash once
every 4
seconds
LED flash once
every 2
seconds
LED flash once
every second
3
OFF Mode Table
Status Back-up LED
(Yellow)
AC input LED is OFF
disconnected
AC input normal:
Battery is in
charging
AC input normal:
Battery is fully
charged
UPS working LED flash once
schedule: Set via every 2
Smart USB port seconds
Fault Table
Status Back-up LED
(Yellow)
Over-temperature Depends on AC input or load
Overload condition
Output short
circuit
LCD version:
No. Indicator Description
1 Input voltage Indicate input Line voltage value. Input voltage will blink continuously in
back up mode
2 Output voltage Indicate output voltage value
3 Battery capacity Estimated battery capacity, the accuracy is influenced by UPS operation
mode and load level.
4 Load capacity The load level. Percentage of full load
5 Fault Icon is lighted: UPS is in fault condition and alarm will beep continuously
6 Battery Icon is lighted: UPS is on back up mode when AC power is abnormal.
7 Battery fail Icon is lighted: UPS battery is abnormal, please check or replacement
battery.
8 Normal Icon is lighted: UPS is under normal status.
9 Overload Icon is lighted: UPS is overloaded, buzzer will beep continuously. Please
remove some loads.
On-line LED Cut-off LED (Red) Buzzer
(Green)
LED is OFF LED is OFF Buzzer is OFF
LED flash once Depends on fault
every 2 seconds condition
LED is OFF
Refer to On-line LED is OFF
LED(Green) of
AC mode
On-line LED Cut-off LED (Red) Buzzer
(Green)
LED is OFF Rapid beeping
LED flash twice Constant tone
every second
LED is ON Rapid beeping
4