Emptying The Water Tank; Continuous Drainage - Flama 1327FL Manual De Instrucciones

reminder that the water tank is full and
needs to be emptied.
Restarting the air filter
Press and hold the rest button for 3
seconds to restart the air filter. Once the
dehumidifier has been in operation for 600
hours, the air filter indicator light will turn
on as a reminder to clean the air filter and
the dehumidifier will not work.
Proceed to clean the filter.
Press and hold the button for some time to
restart the air filter.
Fan control button
The fan speed can only be adjusted in
automatic mode.
Press this button to alternate between high
and low fan speed. The corresponding fan
speed indicator will turn on.

EMPTYING THE WATER TANK

When the water tank is full, the dehumidifier
will emit an alert sound and the "full tank"
light will turn on.
Press the STANDBY button to turn off the
dehumidifier.
Pull on the water tank and simply slide it
out of the body of the humidifier.
Empty the water down a drain or outside.
Clean the interior and exterior of the water
tank.
Return the empty
dehumidifier.
Press the POWER button to resume
operation.
If the "full tank" button does not turn off,
make sure that the water tank and float are
correctly positioned.
water tank to
English
Notice
Do not discard the water tank magnets and
plastic rivets. Otherwise, the dehumidifier
will not automatically stop working when
the water tank is full, and the condensed
water will overflow and damage the floor
of the room it is in.
Make sure to clean the condensed water in
the water tank before restarting operation
of the dehumidifier.
If the water tank is dirty, rinse it with clean
water. Avoid using detergents, chemical
dust removers, diesel oil, benzene, thinners
or other solvents. These will damage the
water tank and cause leaks.
Return the empty water tank to dehumidifier.
Otherwise, the full tank indicator will
remain red and the dehumidifier cannot
restart.

CONTINUOUS DRAINAGE

For continuous operation or automatic
dehumidification, connect the drain hose
to the dehumidifier. The condensed water
can automatically flow to a bucket or drain
by gravity.
Straighten the drainage tube.
Insert one end of the hose into the cistern
orifice and connect the other end to the
bathtub, outdoors, a bucket-like recipient,
or to a designated drainage area.
How to correctly place the drainage hose
In continuous drainage mode, the hose
should be placed below the drainage
orifice. Avoid uneven surfaces and do not
bend the hose.
29