Tabla de contenido
STEP 5 – THE FINISHING TOUCHES
•
Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.
•
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the skin
and then work downwards.
SHORT TAPERED STYLES – "FLAT TOPS" & SHORT CUTS
•
Starting with the longest fixed comb (25mm), cut from the back of the neck to the
crown. Hold the guide comb flat against the head and slowly move the clipper through
the hair.
•
Use the same procedure from the lower side to the upper side of the head. Then cut the
hair against the direction in which it grows and level with the sides.
•
To give a "flat top" look, the hair on top of the head must be cut over the top of a flat comb.
•
Use a closer guide comb to taper the hair down to the neckline as desired.
CLEANING AND MAINTENANCE
•
To ensure long lasting performance of your clipper, clean the blades and unit regularly.
•
Ensure the appliance is switched off and unplugged from the mains before cleaning.
•
Do not use harsh or corrosive cleaners on the units or their blades.
•
Cleaning should be done with a soft brush.
•
After each use - Brush the accumulated hair from the blades.
•
Ensure the appliance is switched off and unplugged from the mains.
•
To clean the unit, wipe with a damp cloth and dry immediately.
•
Suitable for cleaning under an open water tap.
WASHABLE CLEANING
•
The clipper is fully washable and can be easily cleaned under a running tap.
•
Press the blade release point to slide out the blade. Then the blade set can easily be
cleaned under the tap.
•
Once the blades are cleaned and dry, place the blade set on top of the clipper and push
it towards the hair clipper until it snaps into place.
•
We recommend that you oil the blades regularly. Add a few drops on all gliding surfaces,
the cutting area and back pads of the blades.
•
Note: A hex wrench is provided to enable you to take the blade apart for deep cleansing
and also remove the taper lever if it needs to be replaced.
EVERY SIX MONTHS
•
The blade assembly can be taken apart for deep cleansing.
•
Use the provided hex wrench to remove the two blade fasteners.
•
The blade will come apart in 3 pieces, that can be wiped and cleaned.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
7
Tabla de contenido
