Ibiza sound STREET-WAVE-MAX Manual De Instrucciones página 5

MANUAL - STREET-WAVE-MAX
USB MODE:
•
Press MODE to select "USB" and insert the USB device. The unit will automatically read and play the music in
the USB device.
•
Press "▶ǁ" button shortly to pause or play.
•
Shortly press "" button to go to the previous song.
•
Shortly press "" button to go to the next song.
Please note that the 2 USB inputs CANNOT be used at the same time. Unplug the USB device first before you connect another
USB device to the other input.
MICRO-SD MODE:
•
After start up, press MODE to select "SD" and insert the microSD card. The unit will automatically read and
play the music on the microSD card.
•
Press "▶ǁ" key shortly to pause or play the music.
•
Shortly press "" key to skip to the previous track.
•
Shortly press "" key to skip to the next track.
TWS PAIRING MODE:
•
Make sure both speakers are OFF.
•
Go to your phone's Bluetooth interface and make sure that it is not connected to either of the speakers. If
your phone is connected, remove the speakers from the list of available devices.
•
Turn both speakers ON, press the MODE button on both speakers. The word « BLUE » should appear on both
LCD screens and flash intermittently.
•
Press the «  » button on either one of the speakers for 5 seconds. Both units will enter pairing mode.
•
One of the units will show the word « BLUE » on the LCD display. This is the master unit and will act as the left
channel, while the other one will be the slave unit and will act as the right channel.
•
Go to your phone's Bluetooth interface and select « STREET-WAVE » from the list of available devices. If pai-
ring is successful, the word BLUE on the master unit will stop flashing.
•
To disconnect the speakers, select any other mode on either one of the speakers.
TROUBLESHOOTING
Problem Possible cause
No sound when 1: No input sound source
power on
2: Volume knob in the lowest position
3: USB/SD no plug
Distortion of 1: Volume too loud
sound
2: Audio file error
No sound from 1: Microphone socket not fully
the Microphone plugged in
2: Microphone switch is not on
3: Microphone volume too low
No sound from 1: Incompatible song format
the USB/SD card
2: Illegal copy causes failures
3: USB/SD Card not inserted properly
Solution
1: Connect a Line signal
2: Adjust volume
3: Insert a USB/SD Card
1: Reduce volume
2: Check and change the audio file
3: Adjust Bass/Treble via "MENU" and "Main volume"
1: Completely plug in the microphone socket
2: Power on microphone
3: Adjust microphone volume
1: Song format should be MP3/WMA
2: Power off, then power on
3: Insert USB/SD card properly
www.ibiza-light.com
5