Setup And Installation; Power Supply - NARDA 5G FR2 Antenna Instrucciones De Manejo Y Seguridad

5

Setup and installation

5.1

Power supply

The standard power supply is provided via the integrated battery. Therefore
the LNB antenna does not affect the runtime of the SRM-3006 basic unit.
The battery of the LNB antenna is pre-charged upon delivery and must be
fully charged before first use. The LNB antenna can be connected to a
power supply via a USB-C cable for operation and for charging the internal
battery. Connected to a USB power bank, long-term measurements can
also be performed.
Please make sure that the AC power cord is equipped with a ferrite filter
NOTE:
positioned next to the LNB antenna power supply. This is important to
ensure the power supply is in line with the EMF standards mentioned in the
datasheet.
Charging the batteries:
 Mains voltage must correspond to the operating voltage of the charging/
power supply device.
1. Connect the charger/power supply device to the charging USB socket of
the LNB antenna.
2. Connect the charger/power supply to the mains.
 Charging starts immediately.
 The Battery status LED lights red during the charging cycle.
 When the battery is charged, the Battery status LED lights green.
3. Remove charger/power supply device.
Battery error
A red flashing Battery status LED signals a battery error.
 In this case unplug the antenna from the SRM-3006 basic unit and
contact your Narda representative.
Narda
5G LNB Antenna 41