Tabla de contenido
Operating conditions:
Between 0° C and 40° C max. during charging and between -10° C and
60° C max. when discharging with max. relative humidity of 90%. If you
do not use the backup charger for long periods of time, please store it
at between 0° C and 40° C at a max. of 90% relative humidity (for short periods).
Please also charge the battery every 3 months or so during long periods of non-use
to maintain full performance of your Powerbank.
Caution :
Do not use the unit in very cold, very hot or very humid conditions or in
very dusty environments.Do not leave it in the sun.
Avoid contact with flames. There is a risk of explosion!
Fall/Impact:
Protect the device from falls and impacts that may cause the product to
malfunction. In case of damage or deformation, replace the equipment.
Electrostatic discharge:
This product is sensitive to electrostatic discharge. Please protect this
device against electrostatic discharge.
Recycling of batteries:
Devices marked with this symbol are subject to European Directive
2013/56/EU.
Recycling of electronic products:
Devices marked with this symbol are subject to the European Directive 2012/19/EU.
Do not immerse the battery in a liquid. Be sure to unplug the equipment after full
charge, do not leave it plugged in. Do not short-circuit the battery poles. Keep away
from children. Use only the supplied cord or equivalent cord with the same cha-
racteristics.
DC Voltage
Contents
1 x 2500mAh backup charger
1 micro USB / USB power cable (male / male)
1 Instructions for use
Technical datas
Battery // 3.6V / 2500mAh (rechargeable)
Type of battery // Li-ion
Input // 5V 1A
Output // 5V 1A
Average charging time // about 4h (using a 5V / 1A charger)
Charging temperature // 0° C / 40° C
Discharging temperature // -10° C / 60° C
Colour // Black
Dimensions // W. 23 x H. 96 x D. 23mm
Weight // 62g
4
Before charging a device, make sure it is compatible with the PowerBank.
!
Do not install near any heat sources such as radiators, hot air vents, sto-
ves, or other devices that produce heat.
Supplied USB / Micro-USB cable length ~ 10 cm
The supplied USB / micro-USB cable can not be used to transfer data. It must only
be used to charge the PowerBank to an external USB source or to charge a USB
device to the PowerBank.
Main diagram
1
Charge your devices
Charge your powerbank
2
3
Charge indicator
Operation
1. Charge / discharge status.
Charging and discharging are indicated by the warning lights on the unit which can
be interpreted as follows:
Charge status :
In charge : 1 LED flashing
Full charge : 1 LED lit
2. Start / Charge Powerbank / Charge connected devices.
a) Charging the Powerbank
This product is pre-charged so does not need charging before using for the first time.
When the battery is completely discharged, proceed as follows.
Connect the male micro USB jack on the supplied power cable to the Powerbank's
micro USB port as precised in the main diagram.
Then connect the male USB plug of the supplied power cable to a standard USB port
(on your computer) or to a USB charger (mains, car, etc.).
The charging status is shown by the LEDs. When the Powerbank is fully charged
the LED is lit. The Powerbank charging time depends on the power rating of the
power supply
b) Recharging devices using the Powerbank
This Powerbank is equipped with a USB output (1A) .
There are several ways to charge your devices with the Powerbank:
- Solution 1 // Connect the USB cable supplied with the product to the USB output of
the Powerbank and the other end of the cable to the micro USB
socket on your device, charging starts automatically.
- Solution 2 // You can also use your own USB cable to connect the Powerbank on the
Discharge status :
In use : 1 LED lit
Empty : 1 LED flashing
5
Tabla de contenido
