Tabla de contenido
A. GENERAL
WARNING : Always remove the battery pack from the tool before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of dust. Occasionally you may see sparks through the ventilation slots. This is normal and will not
damage your power tool.
appliance after completing your sanding work. Remove any dirt (e.g sand dust). If necessary, clean the sanding pad by removing it from the machine
and put it under clean water.
The ambient temperature range for tool and battery use and storage is 0ºC / +45ºC.
The recommended ambient temperature range for the charging system during charging is 0ºC /+40ºC.
The relative humidity of the area must be not more than 80% without direct exposure to rain and excessive dust content of the air.
There are some user serviceable parts in your power tool. Please refer to the list of spare part list of the manual.
B. INSPECTING THE MOUNTING SCREWS
Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the screws be loose, tighten them immediately.
Failure to do so could result in serious injuries.
C. MAINTENANCE OF THE MOTOR
The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the winding does not become damaged and /or wet with oil
or water.
10. TROUBLE SHOOTING
PROBLEM
PRODUCT DOES NOT START
THE MACHINE STOPS
WORKING AFTER
ROTATING SLOWLY
SPARKING VISIBLE
THROUGH THE HOUSING
AIR VENTS
UNSATISFACTORY RESULT
UNSATISFACTORY RESULT
11. PROTECT OUR ENVIRONMENT
CAUTION : This product has been marked with a symbol relating to removing electric and electronic waste. This means that this product
shall not be discarded with household waste but that it shall be returned to a collection system which conforms to the European WEEE
Directive. Contact your local authorities or stocks for advice on recycling. It will then be recycled or dismantled in order to reduce the
impact on the environment. Electric and electronic equipment can be hazardous for the environment and for human health since they
contain hazardous substances.
POSSIBLE CAUSE
Not connected to power supply
Power battery is defective
Other electrical defect to the product
The battery is low power
The battery is low power
Air vents are blocked
A small amount of sparking may be visible
through the housing vents
Sanding sheet or pad is worn
Too much dust remains on the surface
SOLUTION
Connect to power supply/Battery
Check by a specialist electrician
Check by a specialist electrician
Need to charge the battery pack before operating
Need to charge the battery pack before operating
Clean the air fans by blowing through the air vents
This is normal and does not indicate a problem
Replace with new sheet or pad
Empty the dust collector
FR
ES
PT
sible. Clean the
IT
EL
PL
UA
RO
EN
Tabla de contenido
