Warning: Risk of electrical shock. The main circuit breaker
or fuse must be shut off during installation. Only a licensed
electrician with knowledge and understanding of electrical
systems and safety should complete the installation.
Important safety information.
Please read this and the guide(s) at support.aeotec.
com/nanoshutter carefully. Failure to follow the
recommendations set forth by Aeotec Limited may
be dangerous or cause a violation of the law. The
manufacturer, importer, distributor, and/or reseller
will not be held responsible for any loss or damage
resulting from not following any instructions in this
guide or in other materials.
Only a licensed electrician with knowledge and
understanding of electrical systems and safety should
complete the installation.
The maximum amperage rating for Nano Shutter is 2.5A
for each slot and 5A for both when connecting a motor
load (COSφ=0.4, L/R=7ms).
Nano Shutter is intended for indoor use in dry locations
only. Do not use in damp, moist, and / or wet locations.
2
Samsvarserklæring. Aeotec Limited erklærer at Nano Shutter
overholder kravene og andre relevante bestemmelser i RED 2014/53
/ EU, RoHS 2011/65 / EU, IEC 62321: 2008 og EN 50581: 2012. Den
fullstendige teksten til erklæringen er tilgjengelig på: support.aeotec.
com/nanoshutter/doc
Spesifikasjoner. Z-Wave-enheter opererer mellom 868,40 og 926,3
MHz, avhengig av lokale restriksjoner. Den bruker opptil -0.59dBm
ERP-sender effekt, noe som muliggjør langdistanse-tilkobling.
Fullstendig informasjon om enhetsspesifikasjoner og sertifiseringer
finnes på: support.aeotec.com/nanoshutter/specs
© & ™ Aeotec Limited.
Version: 501014100002 - AB
43
